BEMLTMDF1047

0720-ABZ86-001

Behringer

Generate the sounds of the '70s with the Behringer 1047 Multimode Filter / Resonator, a module for Eurorack that features an authentic reproduction of the original ARP 2500 circuitry, offering a very distinctive sounds used by artists like The Who, Jean Michel Jarre, Vangelis, Kraftwerk, and more.The 1047 consists of a highly resonant 12 dB low-pass / high-pass and 6 dB band-pass filters capable of providing a wide variety of formant shaping and tonal modulation. The 1047 ships with a ribbon power cable and mounting screws.Benefits Classic-sounding 1047 analog multimode filter and resonator module from the 70sAuthentic reproduction of the circuitry from the 2500 SeriesConsists of a highly resonant 12 dB low-pass / high-pass and 6 dB band-pass filters capable of providing a wide variety of formant shaping and tonal modulationFilter simultaneously provides high-pass, band-pass, low-pass, and notch outputsCoarse and fine controls adjust the cutoff frequency of all four filter outputs from 16 Hz to 16 kHz with 2 external control signal inputs and attenuatorsResonance (Q) control adjusts the level of the resonant peak of the low-pass and high-pass filters and the band-pass filter Q from 0.5 to over 256 with an external control signal input and attenuatorResonance (Q) control adjusts the notch filter Q and depth in addition to adding resonanceResonance limit switch can be used to prevent overload when high levels of resonance are requiredNotch freq/fc control allows the notch frequency to be offset above or below fc while simultaneously allowing resonant peaks at fc using the resonance (Q) controlInput attenuator control allows you to optimize signal level and colorationMultimode Filter Resonator The 1047 Multimode Filter / Resonator module is a classic voltage controlled 12 dB per octave state variable filter, that has matched transistor design for a vintage soundCoarse and fine filter frequency controlsResonance (Q) control which acts on all 4 filter outputsResonance limit switch prevents signal overload when high levels of resonance are usedNotch frequency/fc control allows the notch frequency to be adjusted up or down from fc as set by the frequency controlsTwo summed frequency CV attenuatorsResonance (Q) CV attenuator for maximum flexibilitySignal input is also equipped with an attenuatorEndless possibilities of filter curve shape to create the ultimate soundInputs and Outputs The 1047 gives you comprehensive connectivity, filter signal input, FCV 1 and FCV 2 inputs can be used for filter frequency control or modulation, the Q CV input allows modulation of Q and resonance. The independent low-pass, high-pass, band-pass and notch filter outputs are all available simultaneously to feed multiple filter signals to other modules.Eurorack Ready Installing the 1047 Multimode Filter / Resonator module is easy as it is designed to fit into a standard Eurorack case. Just connect the power cable to the power supply, and screw in the module using the included screws. This allows for the 1047 to be mixed with other synth modules for a truly unique setup.Horizontal Pitch: 16 HPPower Requirements: Power: 55mA, +12V; 45mA, -12V